EarthQuaker Devices Scrolls Bass Odyssey

Controls:
Drive Footswitch: Activates the Drive channel
EQ Footswitch: Activates the EQ channel
Drive Controls:
Level: Output volume control for the Drive channel.
Blend: Blends between your clean signal with the Drive signal. Turn the knob fully clockwise for maximum crunchiness.
Drive: Controls the intensity of the overdrive.
Bandwidth: Determines where the clipping is most active. Turn the control counterclockwise to activate low-end clipping for a warmer, softer, rounded, and overall more subdued tone. Turn the control clockwise and activate High-end clipping for a present, focused crunch with a tighter low-end.
Tone: Low pass filter enabling you to shape the frequency of the Drive channel. Turn counterclockwise to reduce highs.
EQ Controls:
Level: Output volume control when the EQ controls are active. Set the knob at noon for unity, turn clockwise to boost the output signal, turn counterclockwise to cut the output signal.
Vari: Boosts or cuts the Variable Frequency control. Position this control at noon for unity (marked with a center detent in the potentiometer.) Turn clockwise from noon to boost the Vari-Freq, or counterclockwise to cut.
Vari-Freq: Variable frequency control for fine-tuning your tone. Adjustable from approximately 20 Hz to 10 kHz.
Treble: The center position is flat and marked with a center detent in the potentiometer. All settings above this point boost the treble and all settings below cut treble.
Bass: The center position is flat and marked with a center detent in the potentiometer. All settings above this point boost the bass and all settings below cut bass.
Middle: The center position is flat and marked with a center detent in the potentiometer. All settings above this point boost the middle and all settings below cut middle.
Deep: 80 Hz Boost.
Process: Low-mid scoop for a more modern sound.
Bright: 5 kHz Boost
Parallel Out: Buffered output carrying your clean signal that is always active. This allows you to route your clean signal to external destinations (amp, DI, separate pedal chain, tuner, etc.)
Direct Out (On Side): Balanced XLR out with a subtle amount of analog filtering added to the signal path to simulate the tonal characteristics of a bass speaker cabinet.
Ground Lift (On Side): Press for ground lift on the XLR output.
Effects Loop: Situated between the Drive and EQ stages. Hard-wired into the signal path and remains active at all times.
Power: This device requires a standard 9-volt DC power supply with a 2.1mm negative center barrel.
Limited Lifetime Warranty
USA MAP price: $349
​Dealer price: $244.30
GTIN-12 (U.P.C.): 810019915819
SKU: EQDSCRLV1USA
Boxed Dimensions: 6.5″ x 5.25″ x 3.25″ / 16.51 cm x 13.335 cm x 8.255 cm
Out of Box Dimensions: 4.75″ x 4.5″ x 2.25″ / 12.065 cm x 11.43 cm x 5.715 cm
Boxed Weight: 1.43 lbs. / 0.6486371 kg.
Out of Box Weight: 1.16 lbs. / 0.5261671 kg.
Switching:
The Drive side of Scrolls uses relay-based, true bypass switching.
The EQ side of Scrolls uses standard on/off switching.
Drive Input Impedance: 500 kΩ
Drive Output Impedance: 100 Ω
EQ Input Impedance: 10 MΩ
EQ Output Impedance: <1 kΩ
Parallel Input Impedance: 10 MΩ
Parallel Output Impedance: 100 Ω
Direct Out Impedance: 100 Ω
Current Draw: 70 mA